Gas Detection Tubes Archives | Electrogas Monitors Ltd.

Dräger-Tubes®

Matt Berry — Fri, 04 May 2018 03:14:03 +0000

Dräger-Tubes®

High precision guaranteed: The Dräger sampling tubes and systems are very reliable in use even with complex compounds and mixtures of substances.

Category: [project-category-list]

Tags: [project-tag-list]



Features



Documentation

Accurate and reliable results
- The hazardous substances in the air are collected using a suitable medium – such as activated carbon, silica gel, or molecular sieves. The sample is then analyzed in a laboratory with the aid of instrumental analysis.
Suitable for complex cases
- Dräger sampling tubes and systems allow for the identification and measurement of different substances even under difficult conditions. Very complex mixtures of substances or cases in which several similar substances are present at the same time can be measured accurately with Dräger Tubes.

Dräger Tubes Product Safety Information Sheet

Dräger Short Term Tubes and Sampling

Dräger Sampling Tubes and Systems

Get More Info

The post Dräger-Tubes® appeared first on Electrogas Monitors Ltd..

RAE Tubes

Matt Berry — Fri, 04 May 2018 04:16:10 +0000

RAE Tubes

RAE Tubes (Colorimetric)

RAE Tubes (colorimetric) enable quick, on-the-spot measurement of a wide range of toxic and combustible gases and vapours. RAE tubes are easy to read and provide a sharp, clear colour change directly corresponding to the concentration of gas present. RAE tubes are compatible with the RAE Systems piston hand pump, a reliable way to draw samples of an exact volume required for the most accurate measurements. The hand pump features a spring-less piston to accurately draw 50 and 100cc samples. The single-use colorimetric gas detection tubes change colour in direct correlation to the concentration of gas present. No calibration is required, and the ergonomic pump can be used even with multiple layers of gloves.

Category: [project-category-list]

Tags: [project-tag-list]



Features



Documentation

Compound-specific measurement of toxic gases and vapours
Single-use
Easy-to-read tubes change colour based on gas concentration
No calibration or other maintenance required
Hand pump features solid metal construction, spring-less piston design
Pump accurately draws 50 and 100 cc volumes
Wide assortment of tubes available to detect over 300 gases and vapours

Hand Pump (LP-1200)

Ergonomic, durable hand pump
Solid metal construction with a lifetime warranty
Springless piston design accurately draws 50 and 100 cc volumes

RAE Colorimetric Gas Tube Datasheet

RAE Colorimetric Gas Tube Manual

Get More Info

The post RAE Tubes appeared first on Electrogas Monitors Ltd..

X-ACT® 7000

Matt Berry — Tue, 05 Jul 2022 01:55:35 +0000

X-ACT® 7000

Dräger X-ACT® 7000

The Dräger X-ACT® 7000 gas analysis system lets you measure gases in the low ppb range, replacing slow, expensive lab analyses with quick, onsite measurements. Consisting of Dräger MicroTubes and an opto-electronic analysis device, it’s extremely easy to use. Simply insert the Dräger MicroTubes, start measuring and then read out the test result.

After an automatic self-test, the X-act 7000 analysis system is immediately ready for use. The automatic drive carefully draws the MicroTube in and positions it. Control your test using the 3-button control and 2.4″ colour display. When the test is complete, the green LED will glow and a message is displayed on the screen. You can store the test result, location and time in the internal data logger and read it later using the Dräger CC Vision software.

Category: [project-category-list]

Tags: [project-tag-list]



Features



Specifications

Dräger MicroTubes



Documentation

160° viewing angle
Day/night reading mode
3-button control
LED status indicator
Sample up to a distance of 45 meters (147.6 feet) using the X-AM Pump
Measures the lowest-quantity concentrations with lab-quality analysis
More safety thanks to high selectivity (substance-specific reactive layers and multiple pre-layers in the Dräger MicroTubes)
Explosion-proof and ready to use
Dust- and splash-resistant
Certified under ATEX and CSA

Size: 195 mm x 85 mm x 70 mm (7.7 in x 3.3 in x 2.8 inches)
Measuring Range and Resolution: Varies, depending on the Dräger MicroTubes in use
Typical Testing Time: From 5 seconds to 1,200 seconds, depending on the Dräger MicroTubes in use and the concentration of the test substance
Operating Temperature: 0 to +50 °C (+32 to +122 °F)
Storage Temperature: -20 to +55 °C (-4 to +131 °F) (Analyzer); +4 to +25 °C (+39 to +77 °F) (Dräger MicroTubes)
Air Pressure: 700 to 1,300 hPa
Humidity: 0 to 95 % relative humidity, non-condensing
Recording of Measured Data: CMOS sensor optics and LED light
Display: 2.4" high contrast, colour display with a resolution of 240 x 320, viewing angle of 160°
Opeating Time: Approx. 600 minutes of testing time
Protection Class: IP54

Sensor Type	Measuring Range	Test Time
Ammonia	1 - 100 ppm	10 - 75 seconds
Ammonia	100 - 2,500 ppm	3 - 45 seconds
Benzene	1 - 150 ppb	100 - 900 seconds
Benzene	0.15 - 10 ppm	25 - 150 seconds
1,3-Butadiene	25 - 500 ppb	200 - 600 seconds
1,3-Butadiene	0.5 - 25 ppm	10 - 280 seconds
Carbon Dioxide	200 - 50,000 ppm	2 - 120 seconds
Carbon Monoxide	10 - 1,000 ppm	5 - 300 seconds
Chlorine	50 - 5,000 ppb	10 - 400 seconds
Ethylene Oxide	25 - 250 ppb	150 - 600 seconds
Ethylene Oxide	0.25 - 10 ppm	100 - 500 seconds
Formaldehyde	5 - 150 ppb	360 - 960 seconds
Formaldehyde	0.15 - 3 ppm	300 - 600 seconds
Hydrochloric Acid	0.5 - 25 ppm	10 - 100 seconds
Hydrocyanic Acid	0.5 - 50 ppm	20 - 180 seconds
Hydrogen Sulphide	0.1 - 50 ppm	5 - 960 seconds
Mercury	0.005 - 0.25 mg/m³	240 - 1,200 seconds
Nitrogen Dioxide	0.25 - 50 ppm	10 - 210 seconds
Nitrous Fumes	0.25 - 50 ppm	5 - 120 seconds
Petroleum Hydrocarbons	10 - 3,000 ppm	10 - 360 seconds
Sulphur Dioxide	0.05 - 5 ppm	20 - 480 seconds
Toluene	10 - 1,000 ppm	6 - 360 seconds
Xylene	10 - 1,000 ppm	10 - 240 seconds

Dräger X-ACT® 7000 Product Information

Request a Demo

Schedule a demo with the experts at Electrogas to experience firsthand the innovative safety solutions we offer. Our team is dedicated to providing personalized demonstrations tailored to your specific needs and requirements.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

The post X-ACT® 7000 appeared first on Electrogas Monitors Ltd..

Dräger Accuro® Pump

Matt Berry — Fri, 04 May 2018 03:56:11 +0000

Dräger Accuro® Pump

Dräger Accuro Pump

Fast measurement with one hand: The Dräger Accuro Pump allows you to use the established Dräger-Tubes to take measurements under extreme conditions. The easy-to-use Dräger-Tubes have already been calibrated and form a perfect unit with the Dräger Accuro Pump.

Category: [project-category-list]

Tags: [project-tag-list]



Features



Specifications



Documentation

Mobile spot measurement: such as the detection of concentration peaks, confined space entry, worst-case scenarios etc.
Functional bellows pump
Draws in 100 ml per stroke
Sampling
One-handed operation: measurements need to take place under extreme conditions, e.g. on ladders, in shafts or when wearing heavy breathing protection.

Size: 170 x 45 x 85 mm
Stroke volume: 100 ±5 cm³
Weight: 250 g
Temperature: -20 °C to +50 °C
Relative humidity: 0 – 95% non-condensing

Dräger Accuro® Pump Information Guide

Get More Info

The post Dräger Accuro® Pump appeared first on Electrogas Monitors Ltd..

HazMat Simultest Kit

Matt Berry — Thu, 09 Jun 2022 23:54:33 +0000

HazMat Simultest Kit

Dräger HazMat Simultest Kit

The Dräger HazMat Simultest Kit is designed to quickly determine the presence of inorganic and organic gases and vapours. Each set consists of five tube sets, each capable of detecting a different type of toxic substance. The Simultaneous Test Sets I, II & III are used to detect toxic substances generated from burning combustible materials, flammable liquids or flammable gases and substances evolving from a chemical leak or spill.

The HazMat Simultest Kit is ready for use in emergency response situations. The measurement procedure is the same for each set, minimizing training. Laminated full-colour instruction cards provide a quick reference on the simple sampling procedures, and accurate interpretation of results, for both the field and laboratory.

Category: [project-category-list]

Tags: [project-tag-list]



Features



Documentation

Up to 50% Time Savings
- Prepackaged sets of 5 tubes. Air is drawn through the 5 tubes simultaneously using the Dräger 5 tube manifold. The time to draw the air sample is less than 1 minute as
  compared to approximately 10 minutes using individual tubes.
Qualifying Gases and Vapours
- Sets I and II are dedicated to inorganic gases and Set III is for organic vapours.
- Set III quickly identifies the presence of ketones, aromatics, alcohols, aliphatics and chlorinated hydrocarbons.
Reliable Performance
- Environmental factors influence reduced to a minimum, ensuring reliable measurements under the toughest environmental conditions.
- Contents are securely packaged in a rugged Pelican case.
No Calibration
- Dräger Tubes are calibrated at the factory and have a 2-year shelf life.
- Accuro Hand Pump does not require calibration
Easy-to-Use
- Ready for immediate use in emergency situations
- Reduced training by utilizing the same measurement procedure
- Full-colour instruction cards

Dräger HazMat Simultest Kit Product Information Sheet

Get More Info

The post HazMat Simultest Kit appeared first on Electrogas Monitors Ltd..